Chloride content of the cold acid extract was determined using a selective ion electrode potentiometer. |
|
This is the simplest version of what is called a linear-displacement transducer, or linear potentiometer. |
|
Nota: If the droop is used from this card, potentiometer P1 of the sensing card must be set to zero. |
|
The controller uses two stock joystick potentiometers, plus another potentiometer that measures the draw on a cable that emerges from the body of the controller. |
|
The voltage is minimum when internal potentiometer P2 has been rotated fully anti-clockwise. |
|
This key, in potentiometer mode, allows the user to adjust the value of the maximum load sent to the power card. |
|
The lower observed value would not cause a problem with the unit's operation and requires a minor adjustment of a potentiometer to correct. |
|
Turn the internal voltage potentiometer P2 on the regulator fully anti-clockwise. |
|
Set Start Delay by adjusting potentiometer so that equipment being monitored can attain normal operating speed before LED 2 can turn off. |
|
A potentiometer for volume control of the monitoring speaker and the headset can be connected. |
|
The start and end can be altered for these sensor types: current, voltage, potentiometer and resistance transmitter. |
|
Rolling and feeding rolls controlled by means of two independent motors of variable speed. This allows separate speed control by a potentiometer. |
|
The speed control signal will require calibration r elative to the m inimum and m aximum s ettings of the potentiometer. |
|
To adjust the potentiometer, check the actual position of the potentiometer stop. |
|
The wave generated by the LFO is considered as a potentiometer, and therefore can be inserted into any MIDI event defined by the user. |
|
Furthermore it is also possible to set the tail sensitivity through a gain channel and the swash plate through the potentiometer. |
|
The powerup test uses the keypad potentiometer as the speed control source for your convenience. |
|
Push button for adjustment of the min. switch point and adjust the potentiometer of the indicating instrument to the desired min. value. |
|
To make the measuring system less sensitive, you have to turn the potentiometer anticlockwise. |
|
If the potentiometer is correctly adjusted but the actuator or the push-rod is not correctly adjusted, the indicator, if it is working properly, will show the actual position of the trim tab. |
|
|
An integrated potentiometer allows the retro-reflective sensor to be adjusted to detect critical objects such as semitransparent sheeting or translucent paper. |
|
When Relay LED 2 goes on, indicating the incoming pulse rate, turn potentiometer CW slightly past this point to obtain an operating setpoint that allows for normal fluctuations due to load and voltage variations. |
|
To appeal to manufacturers and users of potentiometers, the AS5600 features a ratiometric output, mirroring the output of a potentiometer. |
|
Lead in cermet-based trimmer potentiometer elements. |
|
You must calibrate each potentiometer separately. |
|
The load on each generator is compared with the load of the other generators and adjusted via the electric servomotor on the speed governor or a motorized potentiometer until balance is obtained. |
|
The temporary genset was unable to balance the load automatically and there was not enough time for the crew to respond to the unforeseen loss of the No 1 SSG by manually taking up the load with the available potentiometer. |
|
This displacement is converted to an electrical output by a pointer fixed to the mass moving over the surface of a potentiometer attached to the housing. |
|
Since the current supplied to the potentiometer remains constant, the movement of the pointer causes the output voltage to vary directly with the acceleration. |
|
Above each potentiometer were two lighted buttons: a red one, which eliminated the track from the playback, and a white one, which permitted the operator to isolate the track from the rest of the music. |
|
When the ride starts, the computer chooses a low gear using a special derailleur that is controlled by an electric motor, a potentiometer and internal gears. |
|
The blower starts-up at low speed and the furnace elements are activated one by one to reach the temperature programmed by the potentiometer on the furnace control card. |
|
A second linear potentiometer allows the setting the reference position. |
|
When you install the plenum temperature sensor, you can select the plenum temperature set point with a potentiometer installed on the control card. |
|
A prolonged push allows to modify this value using the potentiometer. |
|
Straightforward rotational speed setting with potentiometer. |
|
The T24-RA potentiometer measuring device is also available in a PCB version for OEM integration. |
|
This paper describes a special potentiometer which is used in the standard-cell laboratory of the Bureau of Standards. |
|
Moving the master throttle lever on the bridge transmits an electronic signal to a receiver potentiometer connect by a rack-and-pinion set-up to the throttle adjustment arm. |
|
Whether you buy the encoder or potentiometer version of the sensor, Phidgets sells interface boards that allow you to read these lengths directly into your computer. |
|
|
Engineering samples of Murata's Trimmer Potentiometer PVG3 series are available upon demand. |
|
The Keypad Shall Have Run And Stop Keys And A Manual Speed Potentiometer Function. |
|