I used staples at the top and bottom before face nailing two brads through each short rail of the front and back face frames. |
|
All joints must be glued and the trim fastened with brads, preferably using pneumatic nailers, which leave very small fastener holes. |
|
Attach plywood with panel adhesive and brads and sand it flush with front edge. |
|
His son, Daniel Bisbee, Jr., bought a mill on Second Brook where he made tacks and brads in partnership with Henry Soule. |
|
These were cut to a 3-inch outside measurement and attached from below with glue and brads. |
|
Galvanized brads are great if using an air or electric hammer. |
|
Nails range from the smallest, thinnest brads to large, weighty spikes. |
|
Also, brads from a nail gun become almost invisible when nailed. |
|
To attach the two outer frames to one another, I nailed brads through a 1-inch wood block that I had placed between the frames on the inside perimeter. |
|
After the counter is installed on top of the cabinet, the wood strip is attached to the front edge of the counter using glue and small, air-driven brads. |
|
Cut the vellum in half, and attach each piece to the body with brads. |
|
The mitered corners are glued and nailed together with 1-in. brads. |
|
Into the middle arch of each desk silver-headed brads had been hammered to form a lion, a bear, a ram, a dove, and in the midst a flaming torch. |
|