Trim the exterior of the door with finish carpentry such as columns and a crosshead pediment to extend the width of the door. |
|
Once the crosshead reaches its limit point it returns to the starting position ready to begin the next test. |
|
Optionally available with an adjustable top crosshead, allowing the test area to be adjusted to customers' requirements. |
|
A standard crosshead screwdriver is all that's required for installing and adjusting most of these LVSG products. |
|
The HA range are classical servo-hydraulic testing machines, with a testing actuator mounted in the lower crosshead. |
|
The crosshead of the machine drove down inserting the spade until a solid condition was achieved, then a zero datum position was set. |
|
Instantly, the operator gets clear information about eccentricity values that can be used for control or crosshead adjustments. |
|
Two holders accommodated the various sizes of filter on the lower moving crosshead of the test stand. |
|
The crosshead can be removed to conduct push-pull open-frame tests. |
|
Since the crosshead support had been redesigned to use 4 anchor bolts, these damaged bolts could be simply cut off, and abandoned. |
|
The reason was the big delay time, a result of the low line speeds and the big distance between the measuring system and the extruder crosshead. |
|
During the tube extrusion process, air at atmospheric pressure enters the tube through the core tube on a crosshead die, or the spider leg of an in-line die. |
|
Long return rods connect the crosshead to the crankshaft, on which is fixed the flywheel. |
|
The asphalt testing system is based on the recently developed HB10 load frame, with the hydrostatic actuator, servo-valve and pressure accumulator unit mounted on the upper fixed crosshead. |
|
Many components, such as the flywheel and crosshead, were made of wood in order to simplify construction. |
|
With the testing actuator mounted in the upper crosshead and the series-standard T-slot platform, flexure and component tests can be performed in addition to standard tests. |
|
Mecmesin provided a customised solution based around a 5000N capacity motorised test stand fitted with S-Beam loadcells and a digital height scale for measuring crosshead movement. |
|
The crosshead became part of the piston, and there was no longer any piston rod. |
|
Easy-to-use, the ValuTest-D is operated by a handwheel, which gives basic positional control over the crosshead, enabling forces up to 1000 newtons to be applied. |
|
A secondary ejector or crosshead vacuum pump is used to maintain the vacuum in the system against the small leaks in the pipe connections between carriages and wagons. |
|
|
The boat was built by Alexander Hart at Grangemouth to Symington's design with a vertical cylinder engine and crosshead transmitting power to a crank driving the paddlewheels. |
|