| The collet closer is shaped and sized to, on tightening of the collet closet, radially compress the collet to grip the sheath. |
|
| The shaft of the cutting tool fits into a collet, which in turn fits into the chuck sleeve. |
|
| In wearing the ring, he noticed that when he turned the collet or face of the ring in toward his palm, he became invisible. |
|
| Flipping the collet over to one side makes it come loose, but it can be flipped over only in certain directions. |
|
| Electric motor-driven collet with optionally integrated force and torque measuring. |
|
| If the diamond scraper catches on the solid collet and is difficult to insert, loosening the cutter holder makes insertion easier. |
|
| Additionally, it is almost impossible with this system to make a special collet with vulcanized clamping elements. |
|
| In actual fact, the DECO Sigma 8 type machines operate without arbor, which means that the workpiece is machined in a collet. |
|
| Usually, on the inside of the collet a short distance from the edge, there is a protrusion on which the stone rests. |
|
| He had hoped that granny would be gone by the time he came out of collet, and then he could take a trip around the world with the money. |
|
| Parallel connected with isolated windings and collet adjusted shaft for front or back panel mounting. |
|
| Universal part production by two spindle sizes with short taper mounting for all standard power and collet chucks. |
|
| The necklace in Plate IX, based on the hopvine, is set with thirty different colored gemstones, each mounted in a collet setting with two leaves and three conelike blossoms. |
|
| To ensure better shock resistance and exceptional reliability, the balance-cock is attached at two points and the hairspring is laser-welded at both ends, to the collet and the stud. |
|
| Remember when using TG collets, the collet must be inserted into the locknut prior to assembly to the holder. |
|
| For workpieces with a low external diameter requiring second operations where workpiece is clamped into position, the workpiece often has to be cut-off at a distance from the collet in order for it to be gripped. |
|
| The collet is located directly in the main spindle nose, without using a collet or collet sleeve, hence resulting in a higher degree of accuracy and precision. |
|
| Silicon The improvement of chronometric precision results principally from new silicon products destined for Breguet and Omega, notably through the optimization of the geometry of the balance-springs and collet. |
|
| Direct-drive technology coupled with a frictionless rotary union for collet actuation enable speeds in excess of 600 rpm for highthroughput applications. |
|
| Tried and tested collet fixture system with secure fit on the axle. |
|
|
|
| Eccentric spindle collet for resharpened cutters. |
|
| The same chucking function can be employed for feeding a long workpiece that requires a collet opening, this replaces the traditional «cable tie». |
|
| There is an almost invisible collet that secures the stone to the ring. |
|
| Collar rot forms in the collet between the stem and the root. |
|
