Next screw down the outer locknut and tighten them against each other just like on the other side. |
|
The transformer will be equipped with a sleeve and a locknut for connecting it to the junction box securely. |
|
Once the drain is correctly in position, tighten the locknut with a wrench. |
|
I have placed a dot of paint on the locknut and fork to match up so that mine is centered. |
|
Use anywhere an ordinary locknut is installed to insure positive bonding of conduit to box and prevent loosening due to vibration. |
|
The locknut can then be easily unscrewed without damaging the journal thread. |
|
Fixed axles are a bolt and locknut that require tools to remove and attach the rear wheel to the frame. |
|
The threads of both the bolt and the locknut show damage consistent with a shearing motion. |
|
Check tightening of all bolts and, in particular, the central teeth carrier locknut. |
|
The plain support is adjusted against the collar at the hook shaft by means of a locknut. |
|
Remember when using TG collets, the collet must be inserted into the locknut prior to assembly to the holder. |
|
Once seated in wheelchair, adjust the footrest to correct height by loosening the locknut and sliding the lower footrest tube up or down until desired height is achieved. |
|
Upon installation, the locknut becomes a permanent and secure part of an assembly and will not loosen or fall out. |
|
Loosen the knurled locknut at the lever end of the clutch cable and turn the adjuster sleeve until the correct amount of clutch lever free play is achieved. |
|
The extent of damage was consistent with a full engagement of the bolt in the locknut with two to three threads extending beyond the end face of the nut. |
|
Garda public vehicle inspector Sgt PJ Gallagher said the proper locknut was not used to fit the front wheels. |
|
Clear evidence of extensive wear was also identified on the Nylstop locknut at the rear of the pig. |
|
Once the required height has been reached, tighten the locknut. |
|
Fit an M2 locknut and an M2 clevis on each threaded pushrod. |
|
Component parts, including axle, locknut and bushing, are made of nonrusting stainless steel construction. |
|
|
To prevent the stay from moving, screw a locknut onto the stud. |
|
The locknut is tightened with a torque wrench to secure the barrel. |
|