To replace worn glasspaper, press the clip at the back of the sander and pull out the glasspaper. |
|
The whole float is then given two coats of cellulose sealer and smoothed over with flour grade glasspaper. |
|
The newly cut top surface was sanded flat, and blended in to the nut area with a file and glasspaper. |
|
This course will include painting on glasspaper which will be available in the studio on the day. |
|
If the saw blade has any rust on it, use some steel wool, a wire brush, or fine glasspaper to get as much of the rust off as you can. |
|
Use medium grade glasspaper to smooth the surface, before painting the rebate using an oil-based wood primer. |
|
Once the board is constructed, the upper surface and edges need to be made very smooth and safe by rubbing with sandpaper and then glasspaper. |
|
Clean the cut rebate with the wood chisel and glasspaper, making sure to keep to the depth indicated by the scored lines. |
|
Roughen the surface of the inner tube over and around the puncture, using the glasspaper. |
|
Take the glasspaper and roll it around the screwdriver coarse side in. |
|
Give the woodwork a light rub over with glasspaper and then apply clear preservative. |
|
Then rub the walls with glasspaper to remove all old paste and smooth rough areas. |
|
In September 1827 Walker started calling his new matches 'friction lights' which were supplied with a piece of folded glasspaper. |
|
Glasspaper is fitted to a simple sanding disk or, for a better finish, a foam drum sander which gives a good finish on both flat and shaped surfaces. |
|